The Effect of Annealing Temperature and Quenching Media Variations On Heat Treatment Process of Cu-Zn-Al Shape Memory Alloys For Shape Memory Effect and Microstructure

Mavindra Ramadhani, Rochman Rochiem, Rizki Rizki, M Arfani

Abstract


Shape Memory Alloys (SMA) is a material that can return to its original shape after undergoing mechanical deformation. The most commonly SMA material used is the Ni-Ti alloy. However, it is high cost. So that it is necessary to have alternative materials, for instance Cu-Zn-Al. Several studies related to Cu-Zn-Al Shape Memory Alloys have poor mechanical properties. So there further research required in order to determine the heat treatment process of Cu-Zn-Al Shape Memory Alloys. In this study Cu-21Zn-5Al alloys were given heat treatment with annealing temperature variations (425;550;600°C) and cooling media (brine, dry ice). Annealing process affects the mechanical properties and microstructure of the test material. Cooling media results the cooling rate during solution treatment. Tests in this study include hardness test, metallographic test, XRD test, DSC test, and SME test. From the test results, it was found that all the test variables have the Shape Memory Effect. The variable that had the greatest recovery (38.3%) was annealing temperature of 450°C with the cooling solution media using brine. In addition, the most rapid cooling occurs in the brine cooling media.

Full Text:

PDF

References


____, “ASM Handbook Volume 2 : Properties and Selection : Nonferrous Alloys and Special-Purpose Materials,” ASM International Handbook Committee, 1990.

____, “ASM Handbook Volume 3 : Alloy Phase Diagrams,” ASM International Handbook Committee, 1992.

____, “ASM Handbook Volume 4 : Heat Treating,” ASM International Handbook Committee, 1991.

____, “ASM Handbook Volume 8 : Mechanical Testing and Evaluation,” ASM International Handbook Committee, 2000.

____, “ASM Handbook Volume 9 : Metallography and Microstructures,” ASM International Handbook Committee, 2004.

____, “ASM Handbook Volume 10 : Materials Characterization,” ASM International Handbook Committee, 1992.

____, “ASM Handbook Volume 16 : Machining,” ASM International Handbook Committee, 1995.

Adiguzel,”Smart Materials And The Influence Of Atom Sizes On Martensite Microstructures In Copper-Based Shape Memory Alloys,” Jounral of Materials Processing Technology, 2007.

Alizadeh, Morteza., and Avvazadeh, Mahsa, “Evaluation of Cu-26 Zn-5 Al Shape Memory Alloys Fabricated by Accumulative Roll Bonding Process”. Materials Science and Engineering, vol. 757, pp. 88-94. 2019.

Arif, Saiful, “Pengaruh Parameter Proses Gerinda Permukaan Terhadap Temperatur dan Hasil Penggerindaan,” Kediri: Multitek Indonesia. 2017.




DOI: https://doi.org/10.31284/j.jasmet.2023.v4i1.4486

Refbacks

  • There are currently no refbacks.


Copyright (c) 2023 Mavindra Ramadhani

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

Mailing Address: Journal of Applied Sciences, Management and Engineering Technology - ITATS Institut Teknologi Adhi Tama Surabaya Jl. Arief Rahman Hakim No.100, Surabaya 60117 email: [email protected] Website : https://ejurnal.itats.ac.id/jasmet/index Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.