Rancang Bangun Buck Converter Menggunakan Kontrol Pi untuk Charging Baterai Pada Penerangan Gazebo
Abstract
The amount of energy consumed is steadily rising. Solar, water, and wind energy are among the plethora of limitless energy sources. Solar energy is one of the energies that can be used in Indonesia. This is inextricably linked to Indonesia, which experiences tropical weather. One application for solar energy, which is renewable and ideal for use as an electricity source, is in gazebo. The gazebo is one of the amenities with open space that can be used as an alternative gathering place for various events. It appears that many gazebos do not yet have guest amenities like illumination and charging outlets. It was accomplished by developing a DC bus system. The device uses a 12 V/20 Ah battery as the energy source to charge two cellphones utilizing a DC light load of 12 V/5 W and a 5 volt power supply. A solar cell with a 20 watt output and a maximum voltage of 21,8 volts charges the battery. In order to obtain a constant voltage from the solar cell, a converter design that can lower the voltage is required. Thus, a converter design that can lower the voltage is required to obtain a constant voltage from the solar cell. The Buck Converter was the converter employed in this study. The converter's voltage should be regulated by the use of the PI control method in this study so that it can provide an output voltage with a set value. When the output voltage of the solar panel, which changes with temperature, irradiance, and other parameters, reaches a voltage setting point of 14,4 volts under PI control with the values of kp = 0,2 and ki = 668, the results for this tool are obtained.
Keywords
Full Text:
PDFReferences
N. R. Alham, F. H. Rumawan, M. Muslimin, R. M. Utomo, and A. Maulana, “Aplikasi Photovoltaic Cell (Pv) Terhadap Variasi Beban Elektrik Sebagai Energi Alternatif,” Jurnal Teknik Elektro Uniba (JTE UNIBA), vol. 5, no. 2, pp. 123–129, 2021, doi: 10.36277/jteuniba.v5i2.92.
H. Kovacevic and Z. Stojanovic, “Buck converter controlled by Arduino Uno,” 2016 39th International Convention on Information and Communication Technology, Electronics and Microelectronics, MIPRO 2016 - Proceedings, pp. 1638–1642, 2016, doi: 10.1109/MIPRO.2016.7522401.
R. R. Pahlawan, T. Setya Pambudi, E. B. Syarif, F. I. Kreatif, D. Produk, and J. Barat, “Perancangan Gazebo di Taman Ir.H.Djuanda.”
B. R. Ananda, Implementasi Desain Buck Converter Dengan PID Controller Menggunakan Metode Tuning Genetic Algorithm (GA). 2020.
Riny Sulistyowati, Rony Seto Wibowo, Dedet Candra Riawan, M. Ashari ,Optimum Placement of Measurement Devices on Distribution Networks using Integer Linear K-Means Clustering Method, PRZEGLAD ELEKTROTECHNICZNY, 2020
Hari Agus Sujono, Riny Sulistyowati, Achmad Safi’i, Ciptian Weried Priananda, Photovoltaic farm with maximum power point tracker using hill Climbing algorithm, ARPN Journal of Engineering and Applied Sciences, 2018.
Padillah, Fitra, Syahrial, Saodah, S. Perancangan dan Realisasi Konverter DC-DCTipe Boost Berbasis Mikrokontroler ATMEGA 8535. Jurnal Reka Elkomika,2014.
Setiawan, J., Facta, M., Winardi, B . Perancangan DC Konverter Arus Searah TipeBuck Pada Mode Operasi CCM dan DCM. Semarang , 2015.
Cahyadi, Lukman, W., Andromeda T., Facta, M. Kinerja Konverter Arus Searah TipeBuck Converter Dengan Umpan Balik Tegangan Berbasis TL494. Semarang, 2017.
Satiawan, Wahyu, I.N., Supriono, Citarsa, I.B.F. Desain Buck Converter UntukCharging Baterei Pada Beban Bervariasi. Nusa Tenggara Barat, 2018.
P. Bantul and D. I. Yogyakarta, “Sistem Penyimpanan Baterai Dan Pendistribusian Energi Listrik Plth Pandansimo Bantul, D.I.Yogyakarta,” pp. 1–11.
A. Firmansyah, “Perancangan Sistem Charger Battery Berbasis Mikrokontroller Dengan Rangkaian Buck Converter,” 2018.
DOI: https://doi.org/10.31284/p.snestik.2024.5703
Refbacks
- There are currently no refbacks.
Copyright (c) 2024 nariyah silviana erwanti, riny sulistyowati, Zulfiyan Febrianto
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.