Pengaruh Variasi Massa Raw Material, Jenis Material dan Kedalaman Pemakanan Terhadap Respon Steady State Error pada Motor Penggerak Slider Mesin Lathe Mini

Wahyu Stiyo Budi, Ahmad Anas Arifin, Desmas Arifianto Patriawan


As time goes by, the world's technology is growing rapidly, as evidenced by the existence of manufacturers in the manufacturing sector such as lathe machines. In the lathe industry, it is very necessary to make it easier to work on the manufacture of custom components such as nuts, bolts and others, therefore this research was carried out using the incremental zero point measurement method using a caliper and testing was carried out based on variations including variations in the mass of raw materials, variations depth of eating, variations in material types. Besides that, this study modifies the mini manual lathe machine into an Arduino-based mini lathe machine (Semi-automatic) so that the operation of the machine can minimize the level of loss in terms of time and cost. This research focuses on testing the performance of the cylindrical motor with the method of calculating settling time, steady state error and variations in the type of working material in order to improve accuracy, precision and time efficiency in processing.

Keywords: Steady state errorlathe, spindle



Kurniawan E. Analisis Nilai Penyimpangan Mesin Bubut CNC Pada Benda Kerja Plastik Nylon. 2021; 2: 1–5.

Saputra N. Making CNC Milling Router For Wood Material. 2019; 1–12.

Firmansyah S, Suryanto H, Mudjijanto. Pengaruh Jenis Material Benda Kerja Terhadap Getaran Saat Proses Penyayatan Dan Kekasaran Permukaan Produk Yang Dihasilkan Dengan Menggunakan Mesin Bubut. J Tek Mesin 2021; 1: 30–37.


Mukminin A, Effendi H. Rancang Bangun Mesin Cnc Mini Untuk Mengambar Berbasis Mikrokontroler Arduino Mega 2560. 2018; XX: 34–42.

HAYASHI A. Micro Turning System : A Super Small CNC Precision Lathe for Microfactories. J Japan Soc Grind Eng 2002; 46: 330–333.

Widiyanto AR. Prototype Pembuatan Cnc Dengan Pemanfaatan.

Choirony IV, Hariyanto MS, Ulum M, et al. Rancang Bangun Acrylic Engraver and Cutting Machine Menggunakan CNC Milling 3 Axis Berbasis Mikrokontroler. Elektrika 2021; 13: 13.

Zubaidi A, Fcd M, Mesin P, et al. Terhadap Kekasaran Permukaan. 2012; 8: 40–47.

Nugroho EC, Nugroho A, Hendriyanto I. Prototipe Mesin CNC 2D Berbasis Arduino Uno. Go Infotech J Ilm STMIK AUB 2019; 25: 43.

Patriawan DA, Ulum M, Alqoroni MS, et al. Transient Response Performance Test on Aftermarket Motorcycle Rear Suspension in Indonesia. J Mech Eng Sci Innov 2021; 1: 69–76.


  • There are currently no refbacks.